Hyundai Elantra HD: Output Speed Sensor. Repair procedures (A4CF2) - Automatic Transaxle Control System - Automatic Transaxle System - Hyundai Elantra HD 2006–2010 Service ManualHyundai Elantra HD: Output Speed Sensor. Repair procedures (A4CF2)

Removal

1.
Remove the battery terminal.
2.
Remove the battery and battery tray.
3.
Remove the air duct.
4.
Remove the air cleaner assembly. (Refer to Automatic transaxle's Removal)
5.
Remove the output shaft speed sensor connector(A).

6.
Remove the output shaft speed sensor(A).


Installation

1.
Install the new O-ring to the output shaft speed sensor.
2.
Remove the output shaft speed sensor (A).

Tightening torque :
10~12Nm(1.0~1.2kgf.m, 7~8lb-ft)

While installing the output shaft speed sensor, do not allow dust or other foreign particles to enter the transaxle.

3.
Check the connector for dust, dirt, or oil, then connect the output shaft speed sensor connector (A) securely.

4.
Installation is the reverse of removal.

Output Speed Sensor. Description and Operation (A4CF2)
Description Sensor type 1. Type : Hall Sensor 2. Output voltage : DC 12V ...

Transaxle Oil Temperature Sensor. Description and Operation (A4CF2)
Description Sensor type 1. Type : Thermister 2. Use available temperature :-40~160°C(-40~320°F) ...