Hyundai Elantra HD: Manual Transaxle Shift Control. Repair procedures (M5CF2) - Manual Transaxle Control System - Manual Transaxle System - Hyundai Elantra HD 2006–2010 Service ManualHyundai Elantra HD: Manual Transaxle Shift Control. Repair procedures (M5CF2)

Removal

1.
Remove the upper cover (A) from the center console.
2.
Remove the center console. (refer to Console in BD group)
3.
Remove the snap pin (A) and the clips (B).
4.
Remove the shift lever assembly (A).
5.
Remove the clip (A) from the shift cable.
6.
Remove the retainer (A) and the nuts (B).
In case, remove the crush pad and cowl cross bar. (refer to Crush pad in BD group and Heater unit in HA group)

7.
Remove the cable assembly from the transaxle. (refer to Manual Transaxle’s removal)
8.
Remove the select and shift cable assemblies.

Inspection

1.
Check the select cable for proper operation and for damage.
2.
Check the shift cable for proper operation and for damage.
3.
Check the boots for damage.
4.
Check the boots for wear, abrasion, sticking, restricted movement or damage.
5.
Check for the weak or damaged spring.

Installation

1.
Install the cable assembly placing the select and shift lever in neutral position.(refer to Manual Transaxle’s installation)
2.
Install the retainer (A) and nuts(B).
Tightening torque :
8.8-13.7Nm (0.9-1.4kgf.m, 6.5-10.1Ib-ft)
In case, install the crush pad and cowl cross bar. (refer to Crush pad in BD group and Heater unit in HA group)

3.
Install the clip (A) connecting the shift cable and the shift lever.
4.
Install the shift lever assembly (A).
Tightening torque :
9~14Nm(0.9~1.4kgf.m, 6~9.5Ib-ft)

5.
Move the slide clip (B) of guide member (A) in the direction as shown in the illustration.
Adjust the slide clip fit into the select lever moving the slide clip in the direction.

6.
Install the guide member (A) of the select cable (B).
7.
Adjust the slide clip (B) to fit it into the select lever pin (A) and install the snap pin (C).
Insert the slide clip in the direction as shown in the illustration.

8.
Install the center console (A).
9.
Install the upper cover (A) to the center console.

Manual Transaxle Shift Control. Components and Components Location (M5CF2)
Components(1) 1. Shift lever knob 2. Shift lever assembly 3. Select cable assembly 4. Shift cable assembly 5. Shift lever assembly(Manual Transaxle Side) 6. ...