| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. In this case, use it after inspecting.
|
|
|
The VCM actuator has to be installed at the fully closing positon
of the VCM valve.
If it doesn't, the VCM coupling of the VCM shaft can't be put
in the the VCM actuator.
|
|
1. |
Installation is reverse of removal.
Variable charge motion actuator
installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the VCMA connector (A).
...
Hyundai Elantra MD/UD: Installation
