Hyundai Elantra: Installation - Camshaft Position Sensor (CMPS). Repair 
procedures - Engine Control System - Fuel System - Hyundai Elantra MD 2010-2018 Service manualHyundai Elantra: Installation


Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Apply the engine oil to the O-ring.
Insert the sensor in the installation hole and be careful not to damage when installation.
Be careful not to damage the sensor housing and the connector.
Be careful not to damage the O-ring.
1.
Installation is reverse of removal.

Camshaft position sensor installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


    Removal
    DONT remove the camshaft position sensor during engine running or right after engine stops, ...

    Knock Sensor (KS). Description and Operation
    Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knoc ...