|
1. |
Check the bushing for wear.
|
|
2. |
Check the brake pedal for bending or twisting.
|
|
3. |
Check the brake pedal return spring for damage.
|
|
4. |
Check the stop lamp switch.
|
(1) |
Connect a circuit tester to the connector of stop lamp
switch, and check whether or not there is continuity when the
plunger of the stop lamp switch is pushed in and when it is
released.
|
|
(2) |
The stop lamp switch is in good condition if there is
no continuity when plunger(A) is pushed.
|
|
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad lower panel.
(Refer to the Body ...
1.
Pre-tighten the bracket fixing bolt (A) in dash panel.
2.
Install the brake booster and brake pedal member fixing nuts (A)
secur ...
Hyundai Elantra MD/UD: Inspection
