Hyundai Elantra: Hazard Lamp Switch. Repair procedures - Lighting System - Body Electrical System - Hyundai Elantra HD 2006Ц2010 Service ManualHyundai Elantra: Hazard Lamp Switch. Repair procedures


Inspection

Hazard Lamp Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad center facia panel (A).
(Refer to the Body group - Crash pad)

3.
Disconnect the hazard lamp switch conector.
4.
Operate the switch and check for continuity between terminals with an ohmmeter.

Hazard Lamp Relay
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the ICM relay box connector.
3.
Check for continuity between terminals. There should be continuity between the No.3 and No.12 or No.7 of ICM-B terminals when power and ground are connected to the No.3 and No.17 of ICM-B terminals.
4.
There should be no continuity between the No.3 and No.12 or No.7 of ICM-B terminals when power is disconnected to the No.3 and No.17 of ICM-B terminals.


    Overhead Console Lamp. Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove 2 screws after removing the lens by using a removal tool. ...

    Flasher Unit. Repair procedures
    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel (A). 3. ...