Hyundai Elantra HD: Flasher Unit. Repair procedures - Lighting System - Body Electrical System - Hyundai Elantra HD 2006–2010 Service ManualHyundai Elantra HD: Flasher Unit. Repair procedures

Inspection

1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver crash pad lower panel (A).

3.
Remove the driver crash pad reinforcing panel (A) after loosening 5 bolts.

4.
Remove the flasher unit (A) after loosening the bolt and disconnecting the connector.

5.
Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 3.
6.
Connect the two turn signal lamps in parallel to terminals 1 and 3. Check that the bulbs turn on and off.
The turn signal lamps should flash 60 to 120 times per minute. If one of the front or rear turn signal lamps has an open circuit, the number of flashes will be more than 120 per minute. If operation is not as specified, replace the flash unit.

Hazard Lamp Switch. Repair procedures
Inspection Hazard Lamp Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad center facia panel (A). (Ref ...

Rheostat. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the lower crash pad switch assembly (A) by using the trim remover to ...