Hyundai Elantra HD: Troubleshooting
        
        Troubleshooting
| 
		Symptom | 
		
		Suspect Area | 
		
		Remedy | 
	
| 
		Water leaks from sunroof | 
		
		Dirt accumulated in drain tube | 
		
		Clear dirt inside of drain | 
	
| 
		Clogged drain tube | 
		
		Blow air into drain to remove dirt | 
	|
| 
		Broken or dislocated drain tube, defective or cracked clip | 
		
		Check tube installation and flange contact | 
	|
| 
		Deteriorated roof lid weatherstrip | 
		
		Replace | 
	|
| 
		Excessive roof lid-to-body clearance and improperly fitted weatherstrip | 
		
		Adjust | 
	|
| 
		Wind noise around sunroof | 
		
		Loosen or deformed deflector, gaps in body work | 
		
		Retighten adjust or replace | 
	
| 
		Sunroof lid makes a noise when move | 
		
		Foreign particles lodged in guide rail | 
		
		Check drive cable and guide rails for foreign particles | 
	
| 
		Loosen guide rails and lid | 
		
		Retighten | 
	|
| 
		Motor runs but sunroof does not move or moves only partially | 
		
		Foreign particles lodged in guide rail | 
		
		Check drive cable and guide rails for foreign particles | 
	
| 
		Incorrect engagement of motor pinion with drive cable | 
		
		Check for loosen motor installation and damaged pinion | 
	|
| 
		Decrease in motor`s clutch slipping force | 
		
		Adjust | 
	|
| 
		Increased sunroof sliding resistance or interference of sunroof with 
		drive cables, weatherstrip, etc. due to mal adjustment of sunroof | 
		
		Adjust or replace | 
	|
| 
		Noise in motor (clutch slipping noise from motor when sunroof is fully 
		opened or closed is not an unusual noise | 
		
		Incorrect engagement of motor pinion With drive cable | 
		
		Check pinion installation and Retighten motor | 
	
| 
		Worn out or damaged motor pinion bearing | 
		
		Replace motor assembly | 
	|
| 
		Worn out or deformed drive cable | 
		
		Replace | 
	|
| 
		Door glass fails to operate up and down | 
		
		Incorrect window glass installation | 
		
		Adjust position | 
	
| 
		Damaged or faulty regulator arm or regulator | 
		
		Correct or replace | 
	|
| 
		Door does not open or close completely | 
		
		Incorrect door installation | 
		
		Adjust position | 
	
| 
		Defective door check assembly | 
		
		Correct or replace | 
	|
| 
		Door hinge requires grease | 
		
		Apply grease | 
	|
| 
		Hood does not open or close completely | 
		
		Striker and latch not properly aligned | 
		
		Adjust | 
	
| 
		Incorrectly installed hood | 
		
		Adjust | 
	|
| 
		Incorrect hood bumper height | 
		
		Adjust | 
	|
| 
		Water leak through windshield end rear window | 
		
		Defective seal | 
		
		Fill with sealant | 
	
| 
		Defective flange | 
		
		Correct | 
	


