Description
|
1. |
Mode
|
(1) |
Configuration State
| A. |
All sensors should be in the Low Line (Base) state.
|
| B. |
In Low Line (Base) configuration, sensor transmissions
occur every 3 minutes 20 seconds (nominal) and pressure
is measured every 20 seconds.
|
|
|
(2) |
Normal Fixed Base State
| A. |
Sensor transmissions continue at the Low Line
(Base) configuration defined rates until the state is
either changed by LF command or by the sensor detecting
a condition that requires a temporary change to another
state.
|
| B. |
The LF command to this state must contain the
sensors ID.
|
|
|
(3) |
Storage Auto State :
| A. |
This state is a Low current consumption state.
|
| B. |
Sensors are in this state when they first arrive
at the dealership (either on the vehicle or as replacement
spares).
|
| C. |
In this state, the sensor does not measure pressure
/ temperature / battery level.
|
| D. |
The sensor will not transmit in this state unless
requested to do so by the initiate command.
|
|
|
(4) |
Alert State :
| A. |
The sensor automatically enters this state if
the measured temperature exceeds 230 °F(110 °C) and
over temperature shutdown is likely.
|
| B. |
In this state, pressure is measured every 4 seconds
and RF data transmitted every 4 seconds.
|
| C. |
The state lasts for 1 minute if it is pressure
triggered.
|
| D. |
This state is alse entered when a 3 psi change
in pressure from the last RF transmission occurs.
|
Sensor mode is used to configure sensor
between high line and low line system. TPM sensor
for MD should be set to low line.
|
|
|
|
Description
TREAD Lamp
-
Tire Under Inflation / Leak Warning.
1.
Turn on condition
A.
When tire press ...
Hyundai Elantra MD/UD: TPMS Sensor. Description
and Operation
Description and Operation