Hyundai Elantra HD: SRS Control Module (SRSCM). Repair procedures - SRSCM - Restraint - Hyundai Elantra HD 2006–2010 Service ManualHyundai Elantra HD: SRS Control Module (SRSCM). Repair procedures

Removal

1.
Remove ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at least three minutes.
3.
Disconnect the DAB, PAB, SAB, CAB and BPT connectors.
4.
Remove the floor console. (Refer to BD group)
5.
Press the lock(1), then pull back the connector lever(2) until it clicks.
6.
Disconnect the SRSCM harness connector(A) and (B) from the SRSCM.
7.
Remove the SRSCM mounting nuts (3EA) from the SRSCM, then remove the SRSCM.

Installation

1.
Remove ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at least three minutes.
3.
Install the SRSCM with the SRSCM mounting nuts.
Tightening Torque
: 1.0 ~ 1.4 kgf.m (9.5 ~ 13.5 Nm, 7.0 ~ 10.0 lb.ft)
4.
Connect the SRSCM harness connector.
5.
Install the floor console. (Refer to BD group)
6.
Connect the DAB, PAB, SAB, CAB and BPT connectors.
7.
Reconnect the battery negative cable.
8.
After installing the SRSCM, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Front Impact Sensor (FIS). Description and Operation
Description The front impact sensors (FIS) are installed in the side member. They are remote sensors that detect acceleration due to a collision at their mounting locations. The primary ...