Hyundai Elantra: Removal - Shift Lever. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra: Removal

Shift Lever Assembly Replacement
1.
Remove the center console assembly.
(Refer to "Interior(console)" in BD group.)
2.
Disconnect sports mode connector (A).
3.
Remove the control cable (A).
4.
Remove the shift lever assembly (A) by removing the bolts (B-4ea).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

5.
Installation is the reverse of removal.
Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
Control Cable Replacement
1.
Remove the center console assembly.
(Refer to "Interior(console)" in BD group.)
2.
Remove the control cable (A).
3.
Remove the control cable assembly in the vehicle after removing the nuts (B) and the retainer (A).
Tightening torque:
11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.9 lb-ft)

4.
Remove the nut (C).
Tightening torque:
9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)
5.
Remove the cable (B) from the bracket (A) at transaxle assembly side (Refer to "Automatic Transaxle" in this group).

6.
Remove the control cable inside of cab.

    Inspection
    1. Check the damage and operation of the control cable. 2. Check the damage of the boot. 3. Check the dam ...