Hyundai Elantra: Removal - Alternator. Repair procedures - ISG (Idle Stop & Go) System - Fuel System - Hyundai Elantra MD 2010-2018 Service manualHyundai Elantra: Removal


1.
Disconnect the battery negative (-) cable.
2.
Remove the drive belt.
(Refer to Engine Mechanical System - "Timing Chain")
3.
Disconnect the alternator connector (A) and the cable from the alternator "B" terminal (B).

Tightening torque :
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.9 lb-ft)

4.
Remove the alternator (A) after removing the bolts.

Tightening torque :
[12 mm bolt] 21.6 ~ 32.4 N.m (2.2 ~ 3.3 kgf.m, 15.9 ~ 23.9 lb-ft)
[14 mm bolt] 29.4 ~ 41.2 Nm (3.0 ~ 4.2 kgf.m, 21.7 ~ 30.4 Ib-ft)


    On-vehicle Inpection
    • Check that the battery cables are connected to the correct terminals. ...

    Intallation
    1. Install in the reverse order of removal. Adjust the alternator belt tension ...