|
1. |
Remove the ignition key from the vehicle.
|
|
2. |
Disconnect the battery negative cable from battery and wait for
at least three minutes before beginning work.
|
|
3. |
Connect the clock spring harness connector and horn harness connector
to the clock spring.
|
|
4. |
Set the center position by setting the marks between the clock
spring and the cover into line. The mark (▶◀) should be matched by turning
the clock spring clockwise to the stop and then 3.0 revolutions counterclockwise.
|
|
5. |
Install the steering wheel column shroud and the steering wheel.
(Refer to the Steering System group - "Steering Column and Shaft")
|
|
6. |
Connect the Driver Airbag (DAB) module connector and horn connector,
and then install the Driver Airbag (DAB) module on the steering wheel.
|
|
7. |
Connect the battery negative cable.
|
|
8. |
After installing the airbag, confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
| B. |
Make sure horn button works.
|
|
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
...
Description
The passenger airbag (PAB) is installed inside the crash pad and protects
the front passenger in the event of a frontal crash. The SRSCM determines if
and when to deploy the PAB. ...
Hyundai Elantra MD/UD: Installation
