Hyundai Elantra: BJ Boot Repair procedures - Driveshaft Assembly - Driveshaft and axleHyundai Elantra: BJ Boot Repair procedures

Removal
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - "Front Driveshaft")
2.
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - "TJ Joint")
3.
Remove the Dynamic damper.
(Refer to Driveshaft Assembly - "Dynamic Damper")
4.
Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.
Remove the BJ boot.
6.
Install in the reverse order of removal.
   
Do not disassemble the BJ assembly.
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
The boot band should be replaced with a new one.
7.
Check the front alignment.
(Refer to Suspension System - "Front Alignment")
Installation
1.
To install, reverse the removal procedure.
2.
Using the SST(09495-3K000), secure the BJ boot bands.

   
Do not reuse the boot band.
3.
Install the TJ joint assembly.
(Refer to Driveshaft Assembly - "TJ joint")
4.
Install the front driveshaft.
(Refer to Driveshaft Assembly - "Front Driveshaft")
5.
Check the front alignment.
(Refer to Suspension System - "Front Alignment")
    BJ Boot Components and Components Location
    components (1) 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Snap ring12. TJ housing13. C ...