Hyundai Elantra: Removal - Clutch Pedal. Repair procedures - Clutch System - Clutch System - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra: Removal

•
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
1.
Remove the battery and ECM.
(Refer to "Manual transaxle system" in MT group)
2.
Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.

3.
Disconnect the push rod from the master cylinder by removing the snap pin (A) and washer (B).

4.
Remove the clutch pedal mounting bolt (A) and nuts (B-2ea).
Tightening torque:
(A) 16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
(B) 18.6 ~ 23.5 Nm (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
5.
Disconnect the ignition lock switch connector (C) and clutch switch connector (B).

6.
Remove the clutch pedal and the master cylinder assembly together.


    Inspection
    Clutch Pedal Inspection 1. Measure the clutch pedal height (from the face of the pedal pad to the floor board) and the clutch pedal clevis pin play (measured a ...

    Installation
    1. Installation is in reverse order of removal. • ...