|
1. |
Measure the clutch pedal height (from the face of the pedal pad
to the floor board) and the clutch pedal clevis pin play (measured at
the face of the pedal pad.)
Standard value
Stroke (A): 140 ± 0.3 mm (5.5118 ± 0.0118 in.)
Free play (B): 6 ~ 13 mm (0.2362 ~ 0.5118 in.)
Height (C): 189.1 mm (7.4449 in.)
|
|
| Ignition Lock Switch Inspection |
|
1. |
Disconnect 2P-connector from a ignition lock switch.
|
|
2. |
Disconnect the ignition lock switch. (if you can install a tester
with the switch fixed, this step can be omissible)
|
|
3. |
Check for continuity between terminals. (refer to the table below)
|
• |
If there is difference between what tested and
the table above, replace the ignition lock switch with
a new one.
|
|
Pedal position
|
Clutch switch
|
Ignition lock switch
|
Released
|
Pressed (Continuity)
|
Released (Open)
|
Fully pressed
|
Released (Open)
|
Pressed (Continuity)
|
Standard value
Full stroke (A): 12.0 ± 0.3mm (0.4724 ± 0.0118 in.)
ON-OFF point (B): 2.0 ± 0.3mm (0.0787 ± 0.0118 in)
|
|
•
Do not spill brake fluid on the vehicle; it may damage
the paint if brake fluid does contac ...
Hyundai Elantra MD/UD: Inspection
