Hyundai Elantra: Installation - Brake Pedal. Repair procedures - Brake System - Brake System - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra: Installation

1.
Pre-tighten the bracket fixing bolt (A) in dash panel.
2.
Install the brake booster and brake pedal member fixing nuts (A) securely.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

3.
Tighten the bolt (A) securely in dash panel.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

4.
Install the snap pin (A) and clevis pin (B).

•
Before installing the pin, apply the grease to the clevis pin.
•
Use a new snap pin whenever installing.
5.
Install the stop lamp switch securely.
6.
Connect the stop lamp switch connector (A).

7.
Adjust the brake pedal height and free play.
8.
Check the brake pedal operation after installing the brake pedal.
9.
Install the shower duct (A).
10.
Install the crash pad lower panel.
11.
Reconnect the battery negative cable.

    Inspection
    1. Check the bushing for wear. 2. Check the brake pedal for bending or twisting. 3. Check the brake pedal retur ...

    Adjustment
    Stop lamp switch clearance adjustment If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in), conform to below. 1. Disconnect t ...