Hyundai Elantra MD/UD: Adjustment

Stop lamp switch clearance adjustment

If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in), conform to below.

1.	Disconnect the stop lamp switch connector (A).

2.	Pull the locking plate (A) as indicated by the arrow.

3.	Turn stop lamp switch 45° counterclockwise and remove it.

4.	Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.

5.	After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate (B) by pushing.

Confirm the gap between stop lamp switch and bracket.

Stop lamp clearance:

1.0 ~ 2.0 mm (0.04~ 0.08 in.)

7.	Connect the stop lamp switch connector.

1. Pre-tighten the bracket fixing bolt (A) in dash panel. 2. Install the brake booster and brake pedal member fixing nuts (A) secur ...

Components 1. Guide rod bolt 2. Bleed screw 3. Caliper carrier 4. Caliper body 5. Inner pad shim 6. Brake pad 7. Pad retainer ...