Replacement
Front Seat Belt Replacement
| •
|
When installing the belt, make sure not to damage the
pretensioner.
|
|
|
1. |
Remove the following items first :
| A. |
Front seat assembly
(Refer to the BD group - "Front Seat")
|
| B. |
Front door scuff trim & rear door scuff trim
(Refer to the BD group - "Interior Trim")
|
|
|
2. |
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
|
|
3. |
To remove the seat belt anchor pretensioner (C), keep on pushing
the lock pins (A) as arrow direction.
And then remove the seat belt after pushing the lock pin (B).
|
|
4. |
Remove the center pillar lower trim (A).
|
|
5. |
After loosening the mounting bolt, then remove the center pillar
upper trim (A) .
|
|
6. |
After loosening the mounting bolt, then remove the front seat
belt upper anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
|
|
|
7. |
After disconnecting the pretensioner connector lock pin, remove
the seat belt pretensioner connector (A), loosen the mounting bolts,
then remove the pretensioner (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
|
|
|
8. |
Installation is the reverse of removal.
|
Height Adjust Replacement
|
1. |
Remove the following items first :
| A. |
Front seat assembly
(Refer to the BD group - "Front Seat")
|
| B. |
Front door scuff trim & Rear door scuff tirm
(Refer to the BD group - "Interior Trim")
|
| C. |
Anchor pretensioner & Front seat belt lower anchor
|
| D. |
Center pillar lower trim
(Refer to the BD group - "Interior Trim")
|
| E. |
Center pillar upper trim
(Refer to the BD group - "Interior Trim")
|
| F. |
Front seat belt upper anchor
|
|
|
2. |
After loosening the bolts, then remove the height adjustor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5kgf.m, 28.9 ~ 39.8 lb-ft)
|
|
|
3. |
Installation is the reverse of removal.
|
• |
Replace any damaged clips.
|
|
• |
Make sure the height adjusts properly.
|
|
|
Front Seat Belt Buckle Replacement
|
1. |
Remove the front seat assembly.
(Refer to the BD group - "Front Seat")
|
|
2. |
After loosening the mounting bolt, then remove the front seat
belt buckle (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
|
|
|
3. |
Disconnect the connector mounting clip (A).
|
|
4. |
Installation is the reverse of removal.
|
Components
1. Front seat belt
2. Height adjuster
3. Anchor pretensioner
4. Rear seat belt [RH]
5. Rear center seat belt
6. Rear seat belt [LH]
7. Rear sea ...
Replacement
Rear Seat Belt Replacement
•
When installing the belt, make sure not to damage the ...
Hyundai Elantra MD/UD: Front Seat Belt. Repair procedures
