Hyundai Elantra HD: Repair procedures
Inspection
Lighting Switch Inspection
| 1. |
With the multi function switch in each position,
make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function
switch
Lighting Switch
Dimmer And Passing Switch
Turn Signal Switch
Front Fog Lamp
|
Wiper And Washer Switch Inspection
| 1. |
With the multi function switch in each position,
make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function
switch.
Wiper Switch
Washer Switch
|
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering column upper and lower shrouds
(A) after removing 3 screws.
(Refer to ST group - Steering column and shaft).
|
| 3. |
Remove the light switch (A) by pushing the lock pin
(B) after disconnecting the connector.
|
| 4. |
Remove the wiper switch (A) by pushing the lock pin
(B) after disconnecting the connector.
|
Installation
| 1. |
Install the wiper switch after connecting the connector.
|
| 2. |
Install the light switch after connecting the connector.
|
| 3. |
Install the steering column upper and lower shrouds.
|
