Hyundai Elantra MD/UD: Removal and Installation - Water pump. Repair procedures - Cooling System - Engine Mechanical System - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra MD/UD: Removal and Installation

1.
Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster.
2.
Remove the drive belt. (Refer to Timing system in this group)
3.
Remove the water pump pulley (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

4.
Remove the water pump assembly (A) with the gasket (B).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

5.
Installation is reverse order of removal
Install a new water pump gasket.
6.
Fill the engine coolant.
7.
Start the engine and check for leaks.
8.
Recheck the coolant level.

Inspection
1. Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary. 2. Check the bearing for damage, abnormal noise ...