Hyundai Elantra MD/UD: Removal

1.	Turm ignition switch OFF and disconnect the negative (-) battery cable.

2.	Remove the battery (A) and ECM (B). (Refer to Engine Electrical group - "Battery")

3.	Disconnect the brake fluid level switch connector (A), and remove the reservoir cap.

Remove the brake fluid from the master cylinder reservoir with a syringe.

•	Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.

Disconnect the brake tube (A) from the master cylinder by loosening the tube flare nut.

Tightening torque:

18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

6.	Remove the clutch hose. [MT only]

Remove the master cylinder (B) from the brake booster after loosening the mounting nuts (A).

Tightening torque:

12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

...

1. Installation is the reverse of removal. 2. After installation, bleed the brake system. (Refer to Brake system bleeding) ...