Hyundai Elantra MD/UD: Removal - Transaxle Oil Temperature Sensor. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra MD/UD: Removal

1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Intake and Exhaust system")
3.
Remove the under cover (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft) )

4.
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid")
5.
Remove the air breather hose (A).
6.
Remove the valve body cover (B).
Tightening torque:
13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.8 ~ 11.6 lb-ft)

7.
Disconnect the oil temperature sensor connector (A).
8.
Remove the oil temperature sensor (A) after removing a bolt.
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Inspection
1. Turn ignition switch OFF. 2. Disconnect the Solenoid valve connector. 3. Measure resistance between sensor ...

Installation
1. Installation is the reverse of removal. After replacement or reinstallatio ...