Hyundai Elantra: Removal - Repair procedures - Manual Transaxle Control System - Manual Transaxle System - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra: Removal

Shift Lever Assembly Replacement
1.
Remove the floor Interior console assembly.
(Refer to "Interior(Console)" in BD group)
2.
Remove the cover (A).
3.
Remove the select cable (B) by removing the snap pin (A).
4.
Remove the shift lever assembly (B) by removing the bolts (A-4ea).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

5.
Remove the shift cable (B) by removing the clip (A).
6.
Installation is the reverse of removal.
•
Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
Shift Cable Replacement
1.
Remove the floor Interior console assembly.
(Refer to "Interior(Console)" in BD group)
2.
Remove the cover (A).
3.
Remove the select cable (B) by removing the snap pin (A).
4.
Remove the shift lever assembly (B) by removing the bolts (A-4ea).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

5.
Remove the shift cable (B) by removing the clip (A).
6.
Remove the retainer (A) and nuts (B-2ea).
Tightening torque:
11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

7.
Disconnect the select and shift cable assembly (B) after removing the pin (A).
8.
Remove the shift cable and select cable at cabin room.

    Inspection
    1. Check the select cable for proper operation and for damage. 2. Check the shift cable for proper operation and for damage. ...