Hyundai Elantra MD/UD: Removal - Heated Oxygen Sensor (HO2S). Repair procedures - Engine Control System - Fuel System - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra MD/UD: Removal

[SULEV]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the connector (A), and then remove the sensor (B).
Note that the SST (Part No.: 09392-2H100) is useful when removing the heated oxygen sensor.
[Bank 1 / Sensor 1]

[Bank 1 / Sensor 2]
[ULEV]
[Bank 1 / Sensor 1]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the connector (A), and then remove the sensor (B).
Note that the SST (Part No.: 09392-2H100) is useful when removing the heated oxygen sensor.

[Bank 1 / Sensor 2]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the console side cover.
3.
Disconnect the connector (A), and then remove the sensor (B).
Note that the SST (Part No.: 09392-2H100) is useful when removing the heated oxygen sensor.


Inspection
1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S termi ...

Installation
• Install the component with the specified torques. • ...