|
1. |
Remove the ignition key from the vehicle.
|
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes.
|
|
3. |
Install the seat belt pretensioner with bolts (B, C).
Tightening torque:
Bolt B: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8
lb-ft)
|
|
|
4. |
Connect the seat belt pretensioner connector (A).
|
|
5. |
Install the upper anchor bolt.
Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
|
|
|
6. |
Install the center pillar trim.
(Refer to the Body group - "Interior trim")
|
|
7. |
Install the door scuff trim.
(Refer to the Body group - "Interior trim")
|
|
8. |
Insert the seat belt to the anchor pretensioner.
|
Make sure the lock pin is connected in properly.
|
|
|
9. |
Reconnect the battery negative cable.
|
|
10. |
After installing the seat belt pretensioner, confirm proper system
operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
To remove the seat belt anchor pre ...
Description
Front seat belt anchor pretensioner operates as well as belt pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on ...
Hyundai Elantra MD/UD: Installation
