|
1. |
Remove the ignition key from the vehicle.
|
|
2. |
Disconnect the battery negative cable from battery and wait for
at least three minutes before beginning work.
|
|
3. |
Place the passenger airbag on the crash pad and tighten the passenger
airbag mounting bolts.
Tightening torque:
8.0 ~ 12.0 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
|
4. |
Install the heater duct to the crash pad.
|
|
5. |
Install the crash pad.
(Refer to the Body group- "Crash pad")
|
|
6. |
Tighten the passenger airbag crash pad mounting bolts.
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
|
7. |
Connect the passenger airbag harness connector to the SRS main
harness connector.
|
|
8. |
Reinstall the glove box. (Refer to the Body group- crash pad)
|
|
9. |
Reconnect the battery negative cable.
|
|
10. |
After installing the passenger airbag (PAB), confirm proper system
operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
1.
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
2.
Remove the glove box housing.
...
Description
The Side Airbags (SAB) are installed inside the front seat and protects
the driver and passenger from danger when side crash occurs. The SRSCM determines
deployment of side airba ...
Hyundai Elantra MD/UD: Installation
