Hyundai Elantra: Inhibiter Switch. Repair procedures (A4CF2) - Automatic Transaxle Control System - Automatic Transaxle System - Hyundai Elantra HD 2006–2010 Service ManualHyundai Elantra: Inhibiter Switch. Repair procedures (A4CF2)

Removal

1.
Remove the battery terminal.
2.
Remove the battery and battery tray.
3.
Remove the air duct.
4.
Remove the air cleaner assembly. (Refer to Automatic transaxle's Removal)
5.
Disconnect the inhibitor switch connector (A).
6.
Remove the control cable(A) from the manual control lever.
7.
Remove the inhibitor switch and manual control lever.

Installation

1.
Set the inhibitor switch to the "N" position.
2.
Set the inhibitor switch control shaft to the "N" position.
3.
Install the inhibitor switch and manual control lever.
Tightening torque :
Shaft nut: 17~21Nm(1.7~2.1kgf.m, 12~15lb-ft)
Bolt(2EA): 10~12Nm(1.0~1.2kgf.m, 7~8lb-ft )
4.
Install the control cable (A) to the manual control lever.
5.
Connect the inhibitor switch connector (A).
6.
Installation is the reverse of the removal.
7.
Turn the ignition switch ON after installation.
Move the shift lever from "P" range to "L" range, and verify that the A/T gear position indicator follows the transaxle range switch.

    Inhibiter Switch. Description and Operation (A4CF2)
    Description Sensor type 1. Type : Rotary 2. Available temperature range : -40~150°C(-40~320°F) ...