Hyundai Elantra HD: Curtain Airbag (CAB) Module. Repair procedures - Airbag Module - Restraint - Hyundai Elantra HD 2006–2010 Service ManualHyundai Elantra HD: Curtain Airbag (CAB) Module. Repair procedures

Removal

1.
Disconnect the battery negative cable and wait for at of least 3 minutes before beginning work.
2.
Remove the following parts. (Refer to BD group)
A.
Side trim, Roof trim
3.
Disconnect the Curtain Airbag harness connector.
4.
After loosening the mounting bolts (9EA), remove the curtain airbag.

Installation

1.
Remove ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at least three minutes.
3.
Install a Curtain Airbag (CAB) on the mounting bracket.
4.
Tighten the CAB mounting bolts (9EA).
Tightening Torque
: 1.1 ~ 1.3 kgf.m(10.8 ~ 12.7 Nm, 7.9 ~ 9.4 lb.ft)
•
Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
5.
Connect the CAB connector.
6.
Install the follwing parts (Refer to BD group)
A.
Side trim, Roof trim
7.
Reconnect the battery negative cable.
8.
After installing the Curtain Airbag (CAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.