Hyundai Elantra: Blower Resistor (Manual) Repair procedures - Blower - Heating, Ventilation and Air ConditioningHyundai Elantra: Blower Resistor (Manual) Repair procedures

Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad center panel.
(Refer to Body - "Crash Pad Center Panel")
3.
Remove the passenger's side shower duct (A) after loosening the screw.

4.
Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws.

5.
To intall, reverse the removal procedure.
    Power Mosfet Repair procedures
    Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until high ...

    Climate Control Air Filter Description and Operation
    Description The climate control air filter is located in the blower unit. It eliminates foreign materials and odor. The particle filter performs a role as an odor filter as well as a conventio ...